No more water damage!

24-hour supervision of your washing machine
and/or dish washer or any other devices using water.

Application:
Households (washing machine, dish washer),
surgeries (e.g. dentists' surgeries, research, laboratories,
any other devices and machines with water connection
(e.g. hot drinks dispensers, cooling devices etc.)

GEWAS 191N                                             

 cpl. and ready for use incl. controller, water probe, solenoid, signal buzzer

GEWAS 191 AN                                                                

cpl. as above but equipped with switch-off mechanism
 for supervised device in case of alarm (up to 16A, 230V, 50Hz)

 

Installation: easy to install - even for unskilled persons - in two minutes without any additional parts or tools being required.
Solenoid valve: glass-fibre reinforced polymide (also used for washing machines). 
Extra low voltage for safety 12 V DC.
Screw connections 3/4" (= 1.905 cm) for direct mounting to water tap or any other standard washing machine or 
dish washer connecting tube 1/2" (= 1.27 cm) with 3/4" (= 1.905 cm) wing/union nut at valve outlet. 
Valve closes automatically in case of power  failure.                                                                                                                                                                                                  
(Min. pressure difiference between inlet and outlet: feed pressure min. 0.5 bar over discharge pressure)
Water sensor:   Highly sensitive plug-in water probe, 2 m cable. Alarm triggered as of 1/2 mm water film. 
Several water probes can be plugged-in and used simultaneously by means of socket outlet 
adapter GAZ 1.2 m 5 m or 10 m plug-in extension cable available.        
Alarm triggering: in case of an alarm the valve closes, the signal buzzer is sounding 
and the device connected is switched off (only for GEWAS 191 A - single pole one-way switch)
Device housing with electronics: enclosed case (not suitable for use in humid environment), electronics, signal buzzer, 
plug connections for valve and water sensor. 
Housing with earthing pin plug connection and socket outlet with earthing contact. 
Looping-in socket outlet with earthing contact used for GEWAS 191; 
alarm controlled socket outlet with earthing contact used for GEWAS 191 A, 
i.e. up to16 A (ohmic load) and 230 V 50 Hz will be switched off in case of alarm.
Power consumption: approx. 3 W only using energy-saving circuitry.

                                                                                                                                                                                                                                                                                                  

Accessories and spare parts (against upcharge):
GMV 91 Spare solenoid
GWF -1 S plug-in water sensor
GAZ -1 socket outlet adapter (required for each additional water sensor)
VEKA 2 extension cable 2 m
VEKA 5 extension cable 5 m
VEKA 10 extension cable 10 m

(c) 1999-2010 GSG Geologie-Service GmbH, Wuerzburg  -  www.geologie-service.com
Tel. +49/931 30 40 8-0; FAX: +49/931 99105-90

- All rights reserved -